If you’re thinking about tackling the task of Car Door Window Replacement yourself, follow these simple steps.
Start by removing your door card. Usually held on my a series of phillips head screws, or 10ml Bolts. Trims and clips will cover these bolts. Once the door card is removed put your key in the ignition and re attach your control switch. Turn the car on to accessories. Take the window regulator mechanical arms) to the position where you can then see the two 10ML or Phillips Head Screws holding the Glass to the Regulator. Undo these two bolts and remove the clips. Clean up the mess of the old Glass with gloves and a vacuum.
Slide the door glass through the top of the door. Make sure its lining up with the rails on either end of the door. This can be the trickiest part. Get the glass to the point where it touched the window regulator in the same way the pre-existing mounts where. Re attach the regulator to the glass. Confirm it goes up and down. Put the window all the way down and remove your master control switch. Start your car to charge the battery for 1 minute then turn off and take the key out of the ignition. Re attach the door card. Be careful with the clips around the edges of the door skin. Re apply the bolts. Re apply the bolt covers. Place the master control switch in the door and test.